Raytracer

Drop CPoints
Place the selected reference point vertically on the lower surface.


Drop CPoints (Trace)
Add corresponding points vertically to the surface below the selected reference point, and add a reference line between them.


Drop Components
Place the selected group or component vertically on the lower surface according to its coordinate points.


Drop Components by Bounds
Place the selected group or component vertically at the bottom corner of its bounding box onto the lower surface.


Grow Components from CPoints
After selecting the component, execute the command to filter the layer where the reference point is located and set the parameters. After confirmation, the component will grow between the point on the layer and the surface below.


Trace Ray Spray from CPoints
A determined amount of scattering is emitted from each reference point in the selection area towards the surface in various directions. The emitted light will be tracked by the reference line and reference point and grouped accordingly.


Spraycan component
Randomly place groups or components on the surface within the circle range. The longer the mouse clicks, the more they will be placed. The circle range can be controlled by modifying the radius in the value box, which can be used for planting trees in mountainous areas.


Place the switch on the ground (Rays Stops at Ground Plane)
Click on or off to allow rays or objects to fall on the virtual ground plane.